Filter
Top Products
Special Characters used when writing dialing
instructions
These characters perform special functions:
& – This is a flash-hook which is critical for signaling on analog systems.
, – The comma is a one second pause.
T – “T” tells the port to switch to tone (DTMF) dialing. This is the default.
W – Wait for answer. On encountering this character, SVMi-4 will monitor the
line for an answer from the called station before dialing any additional charac-
ters. If no answer is detected, the call will fail.
; – The semicolon is wait for dial tone. The SVMi-4 will wait up to twelve sec-
onds for dial tone before dialling any additional characters. If no dial tone is
detected the call will fail. This is useful in environments that may have a short-
age of resources such as a limited number of trunk lines or DTMF receivers.
$K – Stands for key value and causes the SVMi-4 to insert the ID number of the
last Extension block, Mailbox Block, or Menu Block input into a dial string.
Programming - Page 108