Filter
Top Products
Immediately after plugging in the SVMi-4 card and turning the DCS power
switch ON, you MUST press this button to initialize the SVMi-4.
This button should not be pressed if the SCMi-4 is actively processing calls.
Upgrade Key Socket This is the socket where the upgrade key is installed. The
upgrade key will add mailbox capacity and port availability to the SVMi-4. It
will also be necessary to run the SVMi-4 on a DCS 50si.
Back Plane Connectors These are the connectors to the phone system.
Memory Access LED The Memory access LED will flash green whenever the
memory is being accessed. This works in a similar way to the Hard disk access
LED on a PC.
Run Status LED The Run Status LED shows the operating status of the card.
Green = SVMi-4 running normally, Any other condition indicates a fault.
Port Status LED Each LED (1 – 4) will indicate that a call is in progress on
that port.
Memory This device is a compact FLASH media card used for storing the main
system program as well as all messages and prompts. The amount of storage
time on this module is determined by the size of the media card measured in
Mega Bytes (MB). To remove or insert a memory card remove the SVMi-4 from
Installation - Page 31