Samsung ITP-5121D IP Phone User Manual


 
DIALING FROM THE OUTGOING /
INCOMING MENU
From the station idle screen, press the MENU button and select PHONE-
BOOK.
Select OUTGOING CALLS or INCOMING CALLS from the submenu. These
menus will store the last thirty calls made to and from the station.
Press the select button on the display, associated with the number to redial or
use the DIRECTION or SCROLL button to move the cursor to the desired
number. Press the ENTER button to display the detailed information of the
number.
Press the SEND button to dial the number or press ENTER again.
DIALING THE MOST RECENT OUTGOING /
INCOMING NUMBER
Press the SEND button. The most recent call (Internal or External) to or from
the station will be displayed.
Continue to press the SEND button and the system will automatically dial the
number for you.
MAKING CALLS FROM THE CALL LOG
The Station Call Log displays the last outgoing station, and incoming trunk calls.
The total number of calls that can be displayed is 60.You may redial any of these
calls from the Call Log.
Press the SEND button to display the first page of the CALL LOG.
Use the SCROLL button or the DIRECTION button to navigate to the desired
number. Use the UP and DOWN arrows,associated with the top left and right
soft keys to advance and return through the CALL LOG Screens.
When the desired number is highlighted, press the SEND button.
The number will be automatically dialed.
ANSWERING A CALL
Lift the handset and you are automatically connected to the ringing call. See
Ring Preference under Customizing Your KeysetOR—press the SEND button
to automatically answer on the speakerphone.
While a call is ringing in, the display will indicate the type of call coming in
(station number and name,trunk number and name, etc.)
NOTES:
1. If a call is flashing at your keyset but not ringing, you must press the flashing
button to answer.
1716
OUTSIDE CALLS
Note: When making calls,internal or outside calls, in order to access the program-
mable button screens, press the SCREEN button. Then you can utilize either the
SCROLL button or the UP/DOWN arrow (select) buttons on the display.
MAKING AN OUTSIDE CALL
IMPORTANT: Put phone in OVERLAP MODE:
Press the MENU button.
Select SETUP and then select DIAL MODE.
Change it to OVERLAP. If your phone is not in OVERLAP mode you must
always press the SEND button after dialing the digits to send the call.
Lift the handset and press an idle outside line button,line group button or dial
a line access code to receive dial tone—OR—press an idle outside line button,
line group button or dial a line access code to receive dial tone through the
speaker—OR—lift the handset and dial the Trunk Group access code or sim-
ply start dialing.
Dial the telephone number or the Intercom number.
Finish the call by replacing the handset. To disconnect a speakerphone call,
press the END button.
NOTES:
1. You will receive No More Calls tone when you attempt to make a call and
there is no button available for that line.
2. If Least Cost Routing is enabled on your phone system, this button may
be labeled LCR or accessed by dialing an access code (usually 9).
3. If your system is programmed to require an authorization code before
making a call, dial plus a valid code before selecting a C.O.line.
4. If your system is programmed to require an account code before making
a call, press the ACCT button or dial 47 plus a valid bin number, press the
ACCT button again and then select a C.O.line.
For more information on authorization and account codes, see your system
administrator.
NOTE:If the Hot Keypad feature has been turned off,you must first lift the handset
or press the SPEAKER button before dialing.
Home Page
Table of Contents
ITP-5112L