Samsung ITP-5121D IP Phone User Manual


 
BUSY STATION CALLBACK
When you call another station and receive a busy signal:
Press the CBK key, if programmed,or dial 44.
When the busy station becomes free, your keyset will ring.
Lift the handset or press ANS/RLS to call the now idle station.
NOTES:
1. A callback will be canceled if not answered within 30 seconds. If you have set
a callback, your CBK key will light.
2. If the Hot Keypad feature has been turned off, you must first lift the handset
or press the SPEAKER key before dialing.
BUSY STATION CAMP-ON
When you call another station and receive a busy signal but you do not want to
wait for a callback:
MANUAL CAMP-ON
Press the CAMP key or dial 45.
The called station will receive off-hook ring tone repeated every few seconds
and its first available CALL button will flash green to indicate your call is wait-
ing.
Wait for the called party to answer.
The called station must release its first call or place it on hold before answer-
ing your camp-on.
NOTES:
1. If you receive No More Calls tone, that station has no available key to accept
your call. Hang up or leave a message.
2. If the Hot Keypad feature has been turned off, you must first lift the handset
or press the SPEAKER key before dialing.
AUTO CAMP-ON
When you want to automatically camp on to a busy station without pressing the
camp on button every time you call a busy station,you can set your phone for auto
camp-on.
With the handset on-hook, press TRANSFER and then dial 110.
Dial 081 to turn on auto camp-on or 080 to turn it off.
Press TRANSFER to store your selection.
1716
INTERCOM CALLS
CALLING OTHER STATIONS
Dial the extension number or group number.
Wait for the party to answer. If you hear a brief tone burst instead of ringback
tone, the station you called is set for Voice Announce or Auto Answer. Begin
speaking immediately after the tone.
Finish the call by replacing the handset or pressing the ANS/RLS key.
NOTES:
1. If you have a DSS key assigned to an extension or station group, you may
press this key instead of dialing the number.
2. If the Hot Keypad feature has been turned off, you must first lift the handset
or press the SPEAKER key before you begin dialing.
ANSWERING INTERCOM CALLS
When your keyset rings,simply lift the handset—OR—press the ANS/RLS key
to be connected to the calling station.
Finish the call by replacing the handset or pressing the ANS/RLS key.
S
ee
R
ing Preference
under C
ustomizing Your Keyset
.
VOICE ANNOUNCE MODE
When another station calls you,your keyset will sound a brief attention tone and
you will hear the caller’s announcement.
Press ANS/RLS to turn on the microphone and speak handsfree—OR— lift
the handset to reply.
To finish the call, replace the handset or press the ANS/RLS key.
NOTE: In order for C.O. calls to be answered handsfree, AUTO ANS CO must be set
ON.
AUTO ANSWER MODE
When another station calls you,your keyset will sound a brief attention tone and
then automatically answer the call.
Your microphone and speaker are turned on and you can speak handsfree.For
privacy, use the handset.
To finish the call, replace the handset or press the ANS/RLS key.
NOTE: In order for C.O. calls to be answered handsfree, AUTO ANS CO must be set
ON.
Home Page
Table of Contents
iDCS Keyset