Filter
Top Products
5
LCD 24B KEYSET LAYOUT
LABELING PROGRAMMABLE KEYS
Insert the end of a paper clip into the notch of the clear cover. Push
the cover sideways. Lift the cover and remove the designation strip.
Label the designation strip. Replace the strip and cover.
VOL
SPK
HOLD
TRSF
ANS/
1 2ABC
3DEF
4GHI
5JKL 6MNO
7PRS
8TUV 9WXY
0OPER
RLS
SCROLL
HOLD KEY
TRANSFER KEY
ANSWER/RELEASE KEY
PULLOUT
DIRECTORY TRAY
32 CHARACTER DISPLAY Two
lineswith16 characterseach.
SOFT KEYS Used to
activate features via
thedisplay.
SCROLL KEY Used to
scrollthroughdisplays.
16 PROGRAMMABLE
KEYS WITH TRI-
COLORED LIGHTS
Used for CALL buttons,
intercom calls, outside
lines and many other
systemfeatures.
8 PROGRAMMABLE
KEYS WITH RED
LIGHTS Used to call
stations directly, to in-
dicate busy condi-
tions of other sta-
tions,forOne Touch di-
aling and many other
systemfeatures.
VOLUME CONTROL
KEYS Used to set inde-
pendent levels for hand-
set, speaker, back-
ground music, ring and
pagevolumes.
SPEAKER KEY Used to switch
callto speakerphone.
MICROPHONE For
handsfreeoperation.
SPEAKER For handsfree
operationandringing.
4
SYSTEM TONES
The system provides several tones to assist you. Some of these tones are already
familiar to you.
Intercom Dial Tone—A steady tone that indicates you can begin dialing.
DIAL TONE
CONTINUOUS
Ringback Tone—Indicates the station you dialed is ringing.
RINGBACK TONE—1000 ms ON/3000 ms OFF
CONTINUOUS
Busy Tone—Indicates the station you dialed is busy.
BUSY TONE—500 ms ON/500 ms OFF
CONTINUOUS
DND/No More Calls Tone—Fast busy tone indicates the station you
dialed is in the Do Not Disturb mode or cannot receive any more calls.
DND/NO MORE CALLS TONE—250 ms ON/250 ms OFF
FOR TEN SECONDS
Transfer/Conference Tone—Indicates your call is being held and you
can dial another party.
TRANSFER/CONF TONE—100 ms ON/100 ms OFF
CONTINUOUS
Confirmation Tone—Very short beeps followed by dial tone indicate you
have correctly set or canceled a system feature.
CONFIRMATION TONE—50 ms ON/50 ms OFF
FOR ONE SECOND
(programmable)
Error Tone—A distinctive two level beeping tone indicates you have
done something incorrectly. Try again.
ERROR TONE—50 ms of tone 1/50 ms of tone 2
FOR THREE SECONDS
Home Page
Table of Contents
DCS Keyset