Filter
Top Products
Using Your Phone
37
4. To disconnect a single caller, press the
corresponding soft key (
LINE1
or
LINE2
)
to place the caller you wish to keep
speaking to on hold and then press the
END
soft key to hang up the other
caller. For example, to hang up Line 2
but leave Line 1 connected:
• Press the
LINE2
soft key to put Line
1 on hold.
• Press the
END
soft key to hang up
Line2.
• Press the
LINE1
soft key to take Line
1 off hold and continue the
conversation.
To hang up both lines, press
END
.
F
LASH
AND
C
ALL
W
AITING
If you have Call Waiting service and a call
waiting tone sounds while you are on a call,
press
TALK/FLASH
to accept the waiting
call. There is a short pause, and then you
will hear the new caller. To return to the
original caller, press
TALK/FLASH
again.
F
IND
H
ANDSET
To locate the handset, press
PAGE
on the
base when the phone is in standby mode.
The handset beeps for 60 seconds (if you
have two handsets, both handsets beep),
and Paging appears on the handset display.
To cancel paging, press any key on the
handset or
PAGE
on the base. Ô
Ô
NOTE
Ô
If the battery pack is
completely drained, the
handset will not beep
.