Filter
Top Products
Using Your Phone
34
4. Press
CID/VOL/
or
REDIAL/P/
to
choose
Store into PB?
, and then
press the
OK
soft key.
5. To complete the setting, follow the
steps 3-8 in “Storing Phone Numbers,
Names, Distinctive Rings, and Speed
Dial” on page 38.
A
DJUSTING
THE
H
ANDSET
E
ARPIECE
AND
S
PEAKER
V
OLUME
You can adjust the handset earpiece and
speaker volume separately. Ô
Repeatedly pressing the volume up key or
volume down key (labelled as
CID/VOL/
or
REDIAL/P/
key) during a call will change
the earpiece volume of the handset. This
setting will remain in effect after the
telephone call has ended.
D
O
N
OT
D
ISTURB
(DND)
The do not disturb feature (
DND
) allows you
to mute the ringer of the base and any
registered handsets at the same time. If you
have two handsets, the ringer of both
handsets will be muted. To do this, In the
standby mode, press and hold
DND
on the
base. The
DND
LED lights. To cancel ringer
mute, press
DND
again. You can also mute
the ringer tone while the phone is ringing by
pressing
DND
on the base.
To mute the ringer tone temporarily for each
handset or the base, when the phone is
ringing, press
MUTE
on the handset you
want to mute or
!PLAY/
"
STOP
on the
base.
The ringer tone will return to the previous
setting starting with the next incoming call.
Ô
NOTE
Ô
When you press volume up
key (CID/VOL/ ) in the
maximum volume level or
volume down key (REDIAL/
P/ ) in the lowest volume
level, an error tone sounds.