Filter
Top Products
Setting Menu Options
29
2. Press
CID/VOL/
or
REDIAL/P/
to
select
Line1
or
Line2
, and then press
the
OK
soft key.
3. Press the number keypad (
0
-
9
) to enter
a 3-digit area code.
4. Press the
OK
soft key. You will hear a
confirmation tone.
Setting the Dial Mode
Sets the dial mode to tone or pulse. Most
phone systems use tone dialing; the default
setting is tone dialing. Set the dialing mode
to match the dialing system used by your
local phone service.
• If you are not sure of your dialing
system, set the unit to tone dialing.
Make a trial call. If the call connects,
leave the setting as is; otherwise set
the unit to pulse dialing.
• If your phone system requires pulse
dialing and you need to send DTMF
tones in certain situations during a call,
you may switch over to tone dialing
(refer to “Tone Dialing Switch Over” on
page 35).
1. Press the
MENU
soft key. Select the
Global Setup menu, and then the Dial
Mode submenu.
2. Press
CID/VOL/
or
REDIAL/P/
to
select
Line1
or
Line2
, and then press
the
OK
soft key.
3. Press
CID/VOL/
or
REDIAL/P/
to
select
Tone
or
Pulse
(the initial
setting is Tone).
4. Press the
OK
soft key. You will hear a
confirmation tone.