Filter
Top Products
Before Requesting Help
Cordless Telephone
Problem Cause and Remedy
"No link to base
Place on cradle and
try again."is displayed,
and an alarm tone sounds.
• You are too far from the base unit.
Move closer and try again.
oPlace the handset on the base unit and
try again.
oPlug in the AC adaptor.
oRaise the base unit antenna.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
• Locate the handset and the base unit
away from other electrical appliances
(p. 3).
eMove closer to the base unit.
eRaise the base unit antenna.
ePress OH__ to select a clearer
channel in the talk, speakerphone,
intercom or remote operation mode.
The handset does not ring. eThe ringer volume is set to OFF. Set to
HIGH or LOW (p. 19).
The handset display is eThe handset is in the standby mode
blank. (p. 14). Press _, _, CH _) or EDIT
to turn the display on.
The handset display is still eCharge the battery fully (p. 13).
blank after pressing (_,
[-3, CH [_ or EDIT _).
YOUcannot store a name
and phone number in the
directory.
,,You cannot store an item in the
directory while the unit is in the talk or
intercom mode, or while the answering
system is in use.
ode not pause for over 60 seconds while
storing.
?0