Oricom 9800 Cordless Telephone User Manual


  Open as PDF
of 48
 
40
Registration
Yourpackagedhandset(s)arepre-registeredandreadyto
use. It is not recommended that a handset be registered
again unless absolutely necessary.
FromtheHandsetSetupMenu:
1. Press the [
] or [ ] button to scroll to the
REGISTRATIONsub-menu.
2. P re ss t he [
] button to enter the menu.
REGISTRATION1YES2NO---showsinthedisplay
The default setting is “2NO”.
3. Usethetouch-tonepadtoselect[1]forYESor[2]for
NO. Or use the [
] or [ ]buttontoscrollto1YESor
2NO.
4. Ifyouselect1YES,pressthe[
] button to confirm
yourselection.HOLDBASE PAGEWAITFORBEEP
showsinthedisplay.(Yourhandsetshouldbeheldnear
the base during registration process.)
5. Press and hold the [
] button on the base unit you
hearatoneatthehandset.HANDSETXREGISTERED
shows in the handset display, where X is the handset
number.Youmaynowrenameyourhandset.(Referto
Step3&4ofHandsetNameSection)
De-Registration
This feature allows you to remove a registered handset
frombase.Duringthede-registration process,keepthe
handset near the base.
FromtheHandsetSetupMenu:
1. Press the [
] or [ ] button to scroll to the
DEREGISTRATIONsub-menu.
2. Press the [
]buttontoenterthemenu.DE-
REGISTRATION1YES2NO---showsinthedisplay
The default setting is “2NO”.
3. Usethetouch-tonepadtoselect[1]forYESor[2]for
NO. Or use the [
] or [ ]buttontoscrollto1YESor
2NO.
WARNING:
Itisnotrecommendedthatahandsetbede-registeredunless
absolutelynecessarybecauseonceahandsetisde-registered,that
handset’stelephonefeaturescannotbeuseduntilthehandsetisre-
registered.
ADvANCED SETTINGS
 previous next