Oricom 9800 Cordless Telephone User Manual


  Open as PDF
of 48
 
13
Standby Screen
The handset displays the handset number and user name.
USERNAME
HANDSETX
Programming Functions
The system uses a menu structure to give you access to
allofthebuilt-infeatures.Youmayprogramthefollowing
itemsinmainmenu:RoomMonitor,DTAMMessagesand
Handset Setup.
Room Monitor (applicable only with
additional handsets)
1. MakesureyourphoneisOFF(notintalkmode).
2. Press the [
] button to go to the main menu.
3. Press the [
▼
] or [
▲
]buttontoscrolltoROOM
MONITOR.
4. Press [
]buttontoenterROOMMONITOR menu,
ROOMMONITOREXTENSION?showsinthedisplay.
5. Use the keypad to enter the handset number to be
monitored, either 1 or 2.
Note:
When this phone system is expanded (up to 6 handsets),
handsetsarenamedHANDSET1,HANDSET2,
HANDSET3,HANDSET4,HANDSET5andHANDSET
6 respectively.
6. The receiving handset will turn on the microphone and
the originating handset will turn on the speakerphone to
monitor sound from the receiving handset.
Note:
For room monitoring mode to work, the originating
handset must NOT be on the cradle.
While in room monitoring mode, the handsets will emit
an alert tone approximately every 5 seconds if there is an
incomingcall.Youmaypressthe[
]buttontoquitroom
monitor and answer the call.
While in room monitoring mode, the originating handset
can be switched to monitor by handset earpiece
by pressing the
[ ]
button once. Switch back to
speakerphone by pressing the [
] button once.
Press the
[ ]
button on the handset to exit room
monitor mode.
HANDSET SETup
 previous next