Filter
Top Products
4-2 Using the MobilePro
Powering On and Off
Power on the MobilePro as follows.
If you power off, then quickly power on the
MobilePro, your system may erroneously report the presence of
CompactFlash cards.
In addition, repeatedly powering off and quickly powering on, may
cause data loss. NEC Solutions America recommends that you wait ten
seconds after powering off, before powering on the MobilePro.
1. Slide the display panel latch to the right. Lift the display panel up
towards the rear of the unit.
Do not push the display panel beyond its pre-
designed stop point as you open the panel.
2. Locate and press the Power button. To power off the unit, press
the Power button a second time.
Locating the Power button
A – Power Button