Filter
Top Products
Getting Started 1-27
Setting the Infrared Connection Speed
Your MobilePro supports both SIR (115 Kbps) and FIR (4 Mbps) IR
communications. Follow these steps to set the infrared connection
speed.
1. Tap Start, Settings, Control Panel, and double tap MobilePro
Settings.
2. Select the IrDA tab and select the appropriate infrared connection
speed. The infrared connection speed on your MobilePro must be
compatible with the infrared connection speed on your host PC.
3. Tap OK and close the Control Panel.
4. Using your MobilePro stylus, press the soft reset button to reset
your MobilePro (see “Resetting the MobilePro” in Chapter 4).
Continue to the next section to enable the infrared port on your host
PC.
Enabling the Infrared Port
The infrared port on your host PC must be available for
synchronization with your MobilePro. Follow these steps to enable the
infrared port.
1. Access the setup utility on your host PC to verify that the port is
enabled. If required, select FIR support in Setup.
2. Set up infrared software components on your host PC. In the
Windows environment:
! Go to Start, Settings, Control Panel.
! If infrared is disabled, select the options tab and place a check
in the box “Enable infrared communications.”
! Place a check in the boxes: “Search and provide status for
devices in range” and “Install software for Plug and Play
devices within range.”
! Uncheck the box “Limit connection speed to.”
3. Click Apply and click OK.