Filter
Top Products
Mitel
®
5360 IP Phone User Guide – Issue 1, June 2010 Page 9
Getting Started
Using the 5310 IP Conference Unit
Your IP phone can use the 5310 IP Conference Unit (shown below) for full-duplex, advanced IP
conferencing. Use the Conference Controller touch screen to turn the Conference Unit on or off,
to adjust the volume or to put the Conference Unit into Presentation mode. You can only run
one Conference Controller session at a time. If the 5310 Conference Unit is not connected to
your IP phone, the Conference Controller application is not available.
Installation instructions are included with the unit.
Mitel 5310 IP Conference Unit
For information about placing conference calls and adding parties to the conference, see
“Placing Conference Calls” on page 47.
Accessing/Exiting the Conference Controller Application
You must first access the Conference Controller application to use the Conference Unit.
To access the Conference Controller application:
1. Press (Applications).
2. Press Conference Unit.
To exit the Conference Controller application:
Press Close in the Conference Controller application.
Turning the Conference Unit On and Off
The following instructions describe how to turn the Conference Unit on and off.
To turn the Conference Unit on and off:
Press Turn On or Turn Off in the Conference Controller application. If applicable, the
icon appears in the IP phone status line while the Conference Unit is on.
Adjusting the Conference Unit Volume
The following instructions describe how to adjust the Conference Unit volume.
To adjust the Conference Unit volume:
Press Volume Up or Volume Down.
NOTE
Turning the 5310 Conference Unit off terminates the active call. To continue the call
either pick up the handset or press the Speaker button on the IP phone.
5310 IP Conference Unit