Filter
Top Products
Mitel 5330 and 5340 IP Phones User Guide
- 74 -
Note: If the LED on the Cordless accessory does not start to blink after 10 seconds, the
accessory requires charging or is still in factory battery saving mode (handset only). Place the
accessory on the charger and charge. The green LED starts to flash indicating that the
accessory is charging. It could take up to 60 minutes for the green LED to start flashing. Allow
the accessory to fully charge, approximately 3 hours.
4. Press Yes to confirm pairing. The Cordless Devices application confirms the pairing by
displaying the paired device name and its battery level indicator.
5. Press Close to exit.
Pairing a Bluetooth Accessory with a Bluetooth Module
Notes:
An IP phone can have one Bluetooth Handset and up to five Bluetooth headsets (or up
to six headsets if no handset is paired).
To pair a new Bluetooth Handset, you must first unpair the existing Bluetooth Handset.
Pairing cannot be performed when a Bluetooth device is already in use.
To pair a Bluetooth accessory:
1. Ensure that the battery of the Bluetooth device to be paired is at least partially charged.
2. Press and hold the pairing button on the back of the Bluetooth Module for 5 seconds to
activate phone pairing mode. The LED on the Bluetooth Module blinks. The Cordless
Devices application opens on the phone and prompts you to place the accessory in
pairing mode.
3. For Mitel Bluetooth Handsets: Press and hold the hookswitch on the side of the
Bluetooth Handset (see page 77
) for 5 seconds to activate accessory pairing mode. The
LED on the handset blinks. The pairing confirmation window on the IP Phone appears,
displaying the product name for the device to be paired.
Note: If the LED on the handset does not start to blink after 10 seconds, the handset requires
charging or is still in factory battery saving mode. Place the handset on the charger. The
green LED starts to flash indicating that the handset is charging. It could take up to 60
minutes for the green LED to start flashing. Allow the handset to fully charge, approximately 3
hours.
For third-party Bluetooth headsets: Follow the manufacturer’s instructions to place the
Bluetooth headset in pairing mode. The pairing confirmation window on the IP Phone
appears, displaying the product name for the device to be paired.
4. Press Yes to confirm the pairing. The Cordless Devices application prompts you to enter
a passcode.
5. Enter a valid passcode for the Bluetooth device (default is 0000) using the keyboard on
the display, and press OK.
For third-party Bluetooth headsets: An “Auto Connect” window displays. Press Yes if
the phone will not be shared with other users; press No if the phone will be shared with
other users and multiple headsets.