Filter
Top Products
Mitel 5330 and 5340 IP Phones User Guide
- 67 -
USING YOUR PHONE WITH THE 5310 IP
CONFERENCE UNIT
Your phone uses the 5310 IP Conference Unit for conferencing. You use the Conference
Controller to turn the conference unit off or on, to adjust the volume or to put the conference
unit into Presentation mode. You can only run one Conference Controller session at a time. If
the 5310 Conference Unit is not connected to your phone, the Conference Controller
application is not available.
Access the Conference Controller
To access the Conference Controller:
1. Press the blue Menu
key and press Conference Unit, or
2. Press the key programmed to the Conference Unit application.
Turn the Conference Unit On and Off
1. Verify that the conference unit is connected to your phone.
2. Access the Conference Controller. For more information, see Access Conference
Controller.
3. Press Turn On/Turn Off.
Note: Turning the 5310 Conference Unit off will terminate the active call. To continue the call
either pick up the handset or press the Speaker key on the phone.
While the Conference Unit is on, the icon shows in the phone status line.
Adjust the Conference Unit Volume
Press Volume Up or Volume Down.
Place the Conference Unit in Presentation Mode
Presentation Mode is used when only one individual is speaking to a group. If another
member in the group wishes to speak, you must disable Presentation Mode. Presentation
Mode minimizes extraneous noise.
To place the conference unit in Presentation mode
Press Presentation Mode.