Filter
Top Products
Mitel 5330 and 5340 IP Phones User Guide
- 4 -
Ring/Message Indicators
When indicator is it means that
Flashing rapidly Your phone is ringing
Flashing slowly A message or callback message is waiting at your phone
On Your phone is ringing another phone
Off Your phone is idle, or you are on a call
For Users on Resilient Mitel Communications Director (MCD)
Systems
If during a call, you hear a beep repeated every 20 seconds it means that your phone is
switching to a secondary MCD system. The call continues and there is a change in the
operation of some keys and features on your phone. Normal operation resumes when your
phone switches back to the primary system. If your phone is idle and switched to the
secondary system, you'll see a flashing rectangle on the display. The rectangle remains until
the switch to the primary system is complete.
If the phone fails over to the secondary ICP, you have access to your mailbox on the
secondary ICP only if your Administrator has programmed a mailbox for you.
Notes:
The mailbox on the secondary ICP will not contain the same messages as the mailboxes
on the primary ICP. Any preferences that are voice mail related are not carried from the
primary ICP to the secondary ICP. These preferences must be set on both ICPs.
The People and Settings applications do not support resiliency. Your logs, contact
information and any Settings on the primary ICP will not be carried from the primary ICP to
the secondary ICP.
Mitel Line Interface Module
The Line Interface module is an optional device that adds an analog phone line (POTS)
capability to your phone. If Emergency Call Routing is not programmed on your MCD, you
must use the Line Interface Module to dial emergency calls. For more information on
emergency number dialing, refer to Emergency Calls
. If you have a Line Interface Module
connected to your phone, all programming of the Line Interface Module, except the Analog
Key, is done by the Installer when your phone is installed. For more information, refer to
Programming Features on Your Keys
and Using the Line Interface Module.