Filter
Top Products
41
Display Feature Procedures
This section includes the procedures for five display features you may use with the
8405 voice terminal equipped with a display. However, note that the display, along
with the softkeys and display control buttons, can also be used for accessing up to
12 softkey features. For procedures on using the display and softkeys and a list of
the features that can be accessed with the softkeys, see “Using the Display, Softkeys,
and Display Control Buttons” earlier in this guide.
Call Information
You may have as many as 5 call appearance buttons. Beginning with the uppermost
button and going down, the display identifies the buttons as a through e. When the
display shows it represents call information for the first call appearance
button. The next button down would be shown as , and so on, continuing
through if all 5 of the buttons are used for call appearances.
When you dial an extension, that number is shown then replaced by the called
party’s name and extension. When a call is received from another extension, the
caller’s name is shown; when a call is received from outside, “OUTSIDE CALL” or a
trunk identifier is shown.
The display remains in Normal (call-handling) Mode until you activate one of the
other display or softkey features. After using any of these features, return to Normal
(call-handling) Mode by pressing
.
a=
b=
e=
Exit
Exit (Normal)
To return to normal
display after using any
display feature
1 Press
• Display will show call information for the active
call appearance
Inspect
To see who’s calling
(if you are already on
a call)
1 Press
• Name and number of caller are shown if from
extension; “OUTSIDE CALL” or the trunk source
is shown if the call is from outside.
2 Press to return to the display for the present call
✔
Exit
Inspect
Exit