Lucent Technologies 8405 IP Phone User Manual


 
38
Note: If you are using an 8405B or an 8405D voice terminal, you cannot use this
feature. If you are using an 8405B Plus or an 8405D Plus, you have either the
Speaker (listen-only) feature or the Speakerphone (listen and talk) feature. If you
are uncertain whether your voice terminal is set for the Speaker feature or the
Speakerphone feature, check with your system manager.
Use the following procedures if your voice terminal is set for the Speakerphone
(speak and listen) feature.
If the Reset Spkr label appears under the button on your 8405B Plus or
8405D Plus voice terminal, you can use the Reset Speakerphone feature. For
directions on using this feature, see “Reset Speakerphone” in this section.
Speakerphone
Speaker
To place/answer a call
without lifting the
handset, or to use
speakerphone with
any feature
1 Press
Red light next to
goes on steadily
2 Place or answer the call, or access the selected feature
3 Adjust speakerphone volume if necessary
To raise the volume, press the right half of the
Volume control button labeled ;
to lower the volume, press the left half of the
Volume control button labeled
If you have a display, it shows
(There are eight possible volume settings. On the
display, one arrow is the lowest setting, and eight
arrows is the highest setting.)
Note: The Volume control does not affect an
external speakerphone attached to your voice
terminal.
Speaker
Speaker
SPEAKER L>>>>> H