Filter
Top Products
34
Inter-Tel
®
INT3000 User Guide
REDIALING A NUMBER
In an ideal world, someone will always answer the endpoint when you call. But,
because you will occasionally receive a busy signal or no answer, it’s nice to have the
Redial feature. Although most endpoints redial the last number dialed, your system
administrator can program your endpoint to redial the last number saved.
To use the Last Number Dialed feature (if enabled):
Press .
A line is selected automatically and the number is dialed.
To use the Last Number Saved feature (if enabled):
• To save a number: While the endpoint is idle or while listening to intercom dial
tone, press .
This replaces the current number in redial memory with the
last number that you dialed.
• To redial the saved number: While on a call or after selecting a line, press
. A line is selected automatically and the number in redial memory is
dialed.
DISPLAYING INFORMATION ON YOUR ENDPOINT
Your endpoint has two lines of display where you can view information, such as the
date and time or the outside party’s name/number.
Date, Time, Name, and Extension Number Display
You can temporarily display the system date and time, your user name, and your
extension number at any time.
To show the date and time display (while on a call, in do-not-disturb, etc.):
Press and dial .
Outside Party’s Name
If you are currently connected to an outside caller with Caller ID, you can toggle
between displaying the caller’s name and number.
To show the outside party’s name:
Press and dial .
NOTE: If there is no outside party name available, the display shows CANNOT
ACCESS FEATURE.
redial
redial
redial
s
p
cl
3 0 0
s
p
cl
3 7
9