Filter
Top Products
13
FINDING YOUR WAY
Inter-Tel
®
INT3000 User Guide
Direct Wall Mounting
If you do not have a standard wall plate, you can mount your endpoint directly on a
wall. Before mounting your endpoint, consider the following:
• Select a location away from electrical cables, pipes, or other items behind the
mounting location that could cause a hazard when inserting screws into the wall.
• Make sure the wall material is capable of supporting the weight of the Base Unit.
• Use #10 screws with anchoring devices suitable for the wall material where the
Base Unit will be placed.
1. Insert two mounting screws three inches apart. Allow about of an
inch between the wall and screw heads for mounting the end-
point, as shown on the right.
2. Plug and secure the AC Adapter cord by following steps 2 and 3
of the Standard Wall Plate Mounting.
3. Plug one end of the telephone line cord into the LINE jack
on the Base Unit. Then place the telephone cord inside the
molded channel on the bottom of the Wall Mount stand, as
shown on the right.
4. Place the Base Unit on the posts of the wall
screws and push down until it’s firmly
seated, as shown on the right.
5. Plug the other end of the short telephone
cord into a telephone wall jack.
6. Plug the AC Adapter into a standard 120V
AC wall outlet by following step 7 of the
Standard Wall Plate Mounting.