Filter
Top Products
3-9
Linksys SPA9000 Administrator Guide
Document Version 3.01
Chapter 3 Configuring Voice Service and Voicemail
Configuring the SPA400 for PSTN Connectivity or Voicemail
Step 1 If you have closed the Setup Wizard, start it again.
Select I have configured the SPA9000 using the Wizard before on the first page of the Wizard. Then
on the second page, enter the IP address of the SPA9000 and the password and click Next and the system
displays the Main Menu. To determine the IP address of the SPA9000, use IVR option 110.
After using the Setup Wizard to complete the initial configuration of the SPA9000, as described in the
“Using the Wizard for Initial Configuration” section on page 2-13, the system displays the Main Menu
(Figure 3-1).
Step 2 Select Configure SPA400 from the Main Menu.
The system displays the page shown in Figure 3-10.
Figure 3-10 Configure the SPA400—Page 1
Step 3 Complete the configuration of Page 1 as follows:
• Select the SPA400 MAC address from the pull-down selection list.
• Type the Administrator account password, if this has been set.
Step 4 Click Next.
The system displays the page shown in Figure 3-11.