Filter
Top Products
6-33
Linksys SPA9000 Administrator Guide
Document Version 3.01
Chapter 6 SPA9000 Field Reference
Regional Tab
Vertical Service Announcement Codes
Outbound Call Codec Selection Codes
These codes automatically appended to the dial-plan. So no need to include them in dial-plan (although
no harm to do so either).
Feature Dial Services Codes These codes tell the SPA9000 what to do when the user is listening to the first or second
dial tone.
One or more *code can be configured into this parameter, such as *72, or
*72|*74|*67|*82, etc. Max total length is 79 chars. This parameter applies when the user
has a dial tone (first or second dial tone). Enter *code (and the following target number
according to current dial plan) entered at the dial tone triggers the SPA9000 to call the
target number prepended by the *code. For example, after user dials *72, the SPA9000
plays a prompt tone awaiting the user to enter a valid target number. When a complete
number is entered, the SPA9000 sends a INVITE to *72<target_number> as in a normal
call. This feature allows the proxy to process features like call forward (*72) or BLock
Caller ID (*67).
The *codes should not conflict with any of the other vertical service codes internally
processed by the SPA9000. You can empty the corresponding *code that you do not want
to SPA9000 to process.
You can add a parameter to each *code in Features Dial Services Codes to indicate what
tone to play after the *code is entered, such as *72‘c‘|*67‘p‘. Below are a list of allowed
tone parameters (note the use of back quotes surrounding the parameter w/o spaces)
• ‘c‘ = <Cfwd Dial Tone>
• ‘d‘ = <Dial Tone>
• ‘m‘ = <MWI Dial Tone>
• ‘o‘ = <Outside Dial Tone>
• ‘p‘ = <Prompt Dial Tone>
• ‘s‘ = <Second Dial Tone>
• ‘x‘ = No tones are place, x is any digit not used above
If no tone parameter is specified, the SPA9000 plays Prompt tone by default.
If the *code is not to be followed by a phone number, such as *73 to cancel call
forwarding, do not include it in this parameter. In that case, simple add that *code in the
dial plan and the SPA9000 send INVITE *73@..... as usual when user dials *73.
Field Description
Service Annc Base Number Base number for service announcements.
Service Annc Extension Codes Extension codes for service announcements.