Filter
Top Products
4-5
Cisco Unified IP Phone 8941 and 8945 Administration Guide for Cisco Unified Communications Manager 8.5 (SCCP and SIP)
OL-20851-01
Chapter
Network Setup Menu
PC VLAN Allows the phone to interoperate with 3rd party switches
that do not support a voice VLAN. The Admin VLAN ID
option must be set before you can change this option.
1. Make sure the Admin VLAN ID
option is set.
2. Scroll to the PC VLAN option,
press the Edit softkey, and then
enter a new PC VLAN setting.
3. Press the Apply softkey, then
press Save.
SW Port Setup Speed and duplex of the network port. Valid values:
• Auto Negotiate
• 1000 Full—1000-BaseT/full duplex (Supported only
for Cisco Unified IP Phone 8945.)
• 100 Half—100-BaseT/half duplex
• 100 Full—100-BaseT/full duplex
• 10 Half—10-BaseT/half duplex
• 10 Full—10-BaseT/full duplex
If the phone is connected to a switch, configure the port
on the switch to the same speed/duplex as the phone, or
configure both to auto-negotiate.
If you change the setting of this option, you must change
the PC Port Configuration option to the same setting.
1. Unlock network setup options.
2. Scroll to the SW Port Setup
option and then press the Edit
softkey.
3. Scroll to the setting that you
want and then press the Select
button.
PC Port Setup Speed and duplex of the access port. Valid values:
• Auto Negotiate
• 1000 Full—1000-BaseT/full duplex
• 100 Half—100-BaseT/half duplex
• 100 Full—100-BaseT/full duplex
• 10 Half—10-BaseT/half duplex
• 10 Full—10-BaseT/full duplex
If the phone is connected to a switch, configure the port
on the switch to the same speed/duplex as the phone, or
configure both to auto-negotiate.
If you change the setting of this option, you must change
the SW Port Configuration option to the same setting.
1. Unlock network setup options.
2. Scroll to the PC Port Setup
option and then press the Edit
softkey.
3. Scroll to the setting that you
want and then press the Select
button.
LLDP-MED: Switch Port Enables and disables Link Layer Discovery Protocol
Media Endpoint Discovery (LLDP-MED) on the switch
port. Use this setting to force the phone to use a specific
discovery protocol, which should match the protocol
supported by the switch. Settings include:
• Enabled—default
• Disabled
From Cisco Unified CM
Administration, choose
Device > Phone > Phone
Configuration.
Table 4-1 Network Setup Menu Options (continued)
Option Description To Change