Filter
Top Products
CHAPTER
3-1
Cisco Unified IP Phone 8941 and 8945 Administration Guide for Cisco Unified Communications Manager 8.5 (SCCP and SIP)
OL-20851-01
3
Setting Up the Cisco Unified IP Phone
This chapter includes the following topics, which help you install the Cisco Unified IP Phone on an IP
telephony network:
• Before You Begin, page 3-1
• Understanding the Cisco Unified IP Phones 8941 and 8945 Components, page 3-2
• Installing the Cisco Unified IP Phone, page 3-5
• Footstand, page 3-7
• Reducing Power Consumption on the Phone, page 3-7
• Verifying the Phone Startup Process, page 3-10
• Configuring Startup Network Settings, page 3-11
• Configuring Security on the Cisco Unified IP Phone, page 3-11
Note Before you install a Cisco Unified IP phone, you must decide how to configure the phone in your
network. Then you can install the phone and verify its functionality. For more information, see
Chapter 2, “Preparing to Install the Cisco Unified IP Phone on Your Network.”
Before You Begin
Before installing the Cisco Unified IP Phone, review the requirements in these sections:
• Network Requirements, page 3-1
• Cisco Unified Communications Manager Configuration, page 3-2
Network Requirements
For the Cisco Unified IP Phone to successfully operate as a Cisco Unified IP Phone endpoint in your
network, your network must meet the following requirements:
• Working VoIP network:
–
VoIP configured on your Cisco routers and gateways
–
Cisco UnifiedCM installed in your network and configured to handle call processing
• IP network that supports DHCP or manual assignment of IP address, gateway, and subnet mask