Filter
Top Products
95
Release Notes for Cisco CallManager Release 3.0(10)
78-13493-02
Documentation Updates
Server Name Change
Change the CiscoWorks2000 server name by editing the SAenvproperties.ini file
manually, then restarting the Cisco Syslog Collector service. In future releases, an
administrative interface will be available for this purpose.
ValidateDns When CMI receives incoming lamp commands from the voice-mail
system, it normally validates the DN against the NumPlan table. This
is an attempt to verify that the DN matches an existing DN known to
Cisco CallManager. If the DN is not found in NumPlan, an invalid
DN message is sent to the voice mailbox.
Default value: T
Note On a system with a lot of traffic
to and from the voice mail
system, you may choose to skip
this validation process by setting
the ValidateDns parameter
default to F.
VoiceMailPartition CMI requires this parameter is one of four required by to register an
intercept for the voice mail system with which CMI is going to work.
Note Small systems without a
complex dialing plan usually
only need the VoiceMailDn
parameter. The remaining
parameters, DialingPlan,
RouteFilter, and
VoiceMailPartition will default
to empty strings.
Table 11 CMI Service Parameters Not Included in Release 3.0 Documentation (continued)
ParamName Description