Filter
Top Products
28
Remote Access
You can operate your answering machine from
any other external phone, providing it is a
Touchtone™ phone. To do this you need a
security code to prevent unauthorised access.
This code should not be confused with the
separate Synergy PIN number, which is
required for registering and de-registering
handsets on your Synergy 1500 base station.
Setting your Remote Access security code
from your Synergy handset
To set your security code you will need your
Synergy handset. Your code authorises you to
access your messages from any Touchtone™
phone.
• Press ➔ button once. Display shows
ANS PHONE.
• Press ✔ button followed by ➔ button. Display
shows
ANS ON OFF or PLAY, if there are
messages.
• Press ➔ button several times until
ANS SET-UP
appears.
• Press ✔ button. Display shows
REC OGM.
• Press ➔ button several times until display
reads
SEC CODE.
• Press ✔ button. Display shows ‘
150 ‘ with the
1 flashing. This is the default factory setting.
• Enter your own number (between 000 and
999), overwriting the displayed digits one at a
time as each one flashes.
• When your code is fully entered press
✔ button. A confirming tone sounds.
• Your security access code is now set.
• Press and hold ✘ button. Handset display
returns to standby.
Please note
Please keep a reminder of your security code. If you
forget it at any time, simply repeat the above
procedure. It will permit the number to be retrieved
and/or changed.
Please note
To safeguard your messages you should only give
your security code to those who you wish to have
access. Incoming callers wanting to leave a message
will not need a code.
7t Edition ~ 8t October ’98