Filter
Top Products
You have now successfully recorded both of
your outgoing messages,
Answer and Record
and Answer Only.
• Press and hold ✘ to return to standby
immediately, otherwise wait 20 seconds, and
it will return automatically.
17
Adjusting the volume of played back
messages
You can adjust the volume of message playback
at the base station.
There are four settings:
HIGH, MID-LEVEL,
LOW, SILENCE. Changes can be made during:
• Message playback
• While incoming messages are being recorded
• During Call Screening
To decrease the volume:
• Press the MEMO button.
• Each press of the button decreases the
volume one step.
To increase the volume:
• Press the ANSWER ON/OFF button.
• Each press of the button increases the
volume one step.
7t Edition ~ 8t October ’98
Please note:
You may change either of these messages at any
time, using the above procedure. You are not obliged
to record them both at the same time.
Please note:
You must have recorded both personal OGMs
otherwise your Synergy 1500 will use only the
factory pre-recorded messages, see page 15.
Please note:
Recording outgoing messages from a Touchtone™
phone is covered in ‘Remote Access’ (See page 28).