Filter
Top Products
24
Telephone Operation
Basic handset operation
Hold
Press the softkey HOLD to place a call on hold.
Press /PHONE/FLASH or /SPEAKER to resume
the call. Placing a call on hold cancels the MUTE
feature.
When a call is put on hold, the status light on the
top left corner of the cordless handsets will flash
and the IN USE light on the telephone base will
also flash.
NOTE: Any digits currently in the display will be dialed out when
HOLD is released.
Caution: If the call is not resumed in 15 minutes, the originating
handset will ring and the the display will show CALL ON HOLD RING
BACK. If the RING BACK is not answered in 30 seconds, the call will be
disconnected.
You can send an external call to the telephone
base or to another handset if additional handsets
are registered for use with the system.
• Press the softkey HOLD to put the call on hold.
• Press the CENTER NavKey to enter the
Main Menu.
• Press the DOWN NavKey three times to
reach the Intercom listing.
• Press the CENTER NavKey to enter the
Intercom menu.
• Select from the list of destinations: Global page,
BASE, or one of the registered handsets. Press
the CENTER NavKey to confirm selection.
Caution: If the base or handset does not answer the intercom
call in one minute, the intercom ring stops and the call remains on hold
until it times out in fifteen minutes.
12:00AM
HOLD
MUTE
Phone 0:41
Intercom
x 3
Global page
HANDSET 1
Intercom
BASE
FLASH
CANCEL