AKG Acoustics CS 5 Conference Phone User Manual


 
5.1 Introduction
The CS5 VU can be configured either as a delegate station with a voting function or as a chairperson station with vot-
ing and priority functions. Like the CS5 DU, it provides a microphone connection, talk button, two built-in loudspeak-
ers, and two headphone jacks.
The loudspeakers reproduce the main mix ("floor signal") while the headphone jacks allow the user to listen to the floor
signal or one of 63 interpreted languages.
In addition, the CS 5 VU incorporates a chip card reader for user identification by conference control software. A liquid-
crystal display and five soft buttons allow the user to call the meeting to order, initiate ballots, cast their vote, select lan-
guages for the headphone outputs, etc.
5.2 Control Panel, Inputs, and Outputs
Fig. 5: CS5 VU control panel, inputs and outputs.
1 Loudspeakers.
2 Microphone input for connecting any of the gooseneck microphones listed in section 2.
Note: When the microphone is open, the volume of the loudspeakers will be attenuated by a specific amount de-
pending on the polar pattern of the microphone used. The headphones volume will not be affected.
3 Chip card slot
4 Talk button: Basically, pressing the talk button once activates the microphone. The status LED above the button
will be lit. Pressing the talk button again switches the microphone off. The status LED above the button will go out.
Section 5: CS5 VU Voting/Chairperson Station
- 22 -CS 5 User Manual