ADTRAN 3000 Answering Machine User Manual


 
Chapter 3. Using the Express Configuration Program
61203153L2-20 Express 3000 User Manual 3-17
Enable Anonymous Call Rejection
Rejects calls where the calling party number is blocked (anony-
mous). These numbers normally appear as
Private
on a Caller ID
unit. With this option selected, the Express 3000 refuses to ring
the POTS ports. Generally, the caller experiences a busy signal. A
message in the Status Buffer is the only indication that an anony-
mous call has been rejected.
Incoming Voice Call Rejection List
Contains ten numbers that represent the Call Rejection List. This
list is used when the Enable Call Reject List option is checked.
When the Express 3000 detects an incoming Voice or Audio call,
the telephone number of the caller is compared to the numbers in
this list. If a match is found, the call is rejected.
Generally, the format for the number is one seven-digit number.
If calls are not being rejected while the option is enabled and a
number is programmed, check the Status Buffer for the number of
the caller. The number of the caller should match exactly with the
number in the Call Rejection List.
Advanced Tab
Contains advanced instructions for the Express 3000.
V120 Lower Layer Compatibility
Sends a low-level compatibility information element as part of the
setup message.
Connect Timeout
Sets the length of time that the Express 3000 waits for the far-end
unit to answer an outgoing call.
Inactivity Timer
Defines the amount of time (in minutes) the Express 3000 remains
idle before automatically disconnecting the current data call. A
value of 0 indicates the Inactivity Timer is off.
Remote Password
Accepts the six digit numeric password for the remote unit called.
Valid characters are 0 through 9. Alphabetic characters are not ac-
cepted.