Filter
Top Products
61203153L2-20 Express 3000 User Manual C-1
Appendix C
Loop Status Messages
This appendix lists the status line messages and their definitions.
AutoSpid X
The SPID is being attempted by the AutoSpid determination.
X starts at 0 and counts up for each SPID tried.
Call Connect B1
Bearer channel 1 is connected and is active.
Call Connect B2
Bearer channel 2 is connected and is active.
Call Connect B1/B2
Bearer channels 1 and 2 are active.
Disconnecting
The current phone call is being disconnected (hung up).
Getting TEI #1
The Express 3000 is receiving its first TEI from the network.
Getting TEI #2
The Express 3000 is receiving its second TEI from the network.
Link Down
The network interface is not in sync.
Network Loopback
The Express 3000 has been commanded to perform an ISDN
loopback toward the network.
Ready
The unit is ready to make or accept a call.