Filter
Top Products
Appendix A. AT Commands and S-Registers
A-12 Express 3000 User Manual 61203153L2-20
S36 Inactivity Timer
0=Off
1-255=Number of idle minutes before disconnect
S37 Conference/
Call Waiting
Flash-hook button defaults to:
0=Call waiting
1=Call conferencing
S38 X25 TEI = 255
S40 Bond TXINIT
Specifies the number of seconds the originating endpoint
attempts to detect the Async BONDING negotiation
pattern from the answering endpoint before deciding the
Async BONDING call has failed.
0 to 255, 10 sec is default.
S41 Bond TXFA
Specifies the number of seconds both endpoints attempt
to detect the async BONDING frame pattern when a call
is connected before deciding the async BONDING call has
failed. When operating with other manufacturer's async
BONDING equipment, it may be necessary to lengthen
this timer so that it matches TXADD01.
0 to 255, 10 sec is default.
S42 Bond TXADD
The number of seconds both endpoints wait for the
additional call to be connected at the end of negotiation
before deciding the async BONDING call has failed.
When dialing overseas it may be necessary to lengthen
this timer to allow for slower call routing.
0 to 255, 50 sec is default
S43 Bond TXDEQ
The number of seconds both endpoints attempt to
equalize the network delay between the bearer channels
before deciding the Async BONDING call has failed.
0 to 255, 50 sec is default
S44 Bond TANULL
The number of seconds the answering endpoint attempts
to detect the Async BONDING negotiation pattern from
the originating endpoint before aborting to clear channel
mode. It may be necessary to shorten this timer if the DTE
equipment connected to the Express 3000 also has timer
constraints for completing non-BONDING parameter
negotiation.
0 to 255, 10 sec is default
S-Registers List
(Continued)
Command
Function Features