Filter
Top Products
40 CHAPTER 3: BASIC TELEPHONE OPERATION
If the VCX system or the phone reboots or is upgraded with new
software, the ringer resets to the default ringer enabled (feature disabled)
mode.
To mute the phone ringer:
1 Press Feature + 489. The LCD displays:
Ringer is now muted.
2 To clear the display, press the Clear soft button. The next time you receive
an incoming call, the ringer is muted.
3 To turn this feature off, press Feature + 489 again. The LCD displays:
Ringer is now enabled.
4 To clear the display, press the Clear soft button.
Activating Do Not
Disturb
When you enable Do Not Disturb, incoming calls immediately go to the
call coverage point set by you or your administrator. The default call
coverage point is your voice mailbox. The call coverage point is set
through the VCX User Interface (see
Chapter 6).
When your telephone is in Do Not Disturb mode:
■ An incoming call does not cause your phone to ring. If you are logged
in to multiple phones using the same phone number and one of the
phones enables Do Not Disturb, the feature applies to all phones—an
incoming call will not ring on any of the phones.
■ You can use the phone to dial outgoing calls.
■ If you enable Do Not Disturb while one or more calls are ringing, the
pending calls are sent to your call coverage point and Do Not Disturb
is enabled for all subsequent calls.
■ If you are a Hunt Group member and you enable Do Not Disturb,
personal (non-Hunt Group) calls go to your call coverage point.
However, Hunt Group calls always ring on a member’s phone,
regardless of the Do Not Disturb setting.
If your telephone is part of a bridged extension, see Do Not Disturb and
Bridged Line Calls for additional information.