Filter
Top Products
39
IN CASE OF DIFFICULTY
COMMON CURE FOR ELECTRONIC
EQUIPMENT
Electronics, like people, can sometimes
get confused. If the unit does not seem to
be responding normally, then try putting
the Handset in the cradle to re-initialize
the unit. If it still does not seem to respond,
perform the following steps (in the order
listed):
1. Disconnect the power to the Base
Unit.
2 Remove the Handset battery Pack
3. Wait a few minutes.
4. Connect power to the Base Unit.
5. Install the Handset battery pack.
6. Watch for the Handset to display
“ FOUND CHANNEL X”.
YOUR CALLER FADES IN AND OUT.
You may be nearly out of range. Move
closer, or relocate the base.
YOU HEAR OTHER CALLS WHILE
USING YOUR PHONE.
• Replace the Handset in the base cra-
dle, wait a few moments and try
again.
• Disconnect your Base Unit from the
telephone jack, and plug in a regular
telephone. If you still hear other calls,
the problem is probably in your wir-
ing or local service. Call your local
telephone company.
YOU HEAR NOISE IN THE HANDSET,
AND NONE OF THE KEYS OR BUT-
TONS WORK.
• Make sure the power cord is plugged
in.
• Your Base Unit and Handset may not
be operating on the same channel
or security code. Place the Handset
in the cradle for a few moments to
reload the security code and reset
the channel.