Filter
Top Products
20
MAKING CALLS
Extend the Antenna whenever you
remove the Handset from the Base
Unit cradle
There are two ways to make a call:
• Press LINE 1/FLASH or LINE 2/
FLASH and listen for dial tone. The
LCD will display
HANDSET ON 1
(or
2
). Dial the phone number.
OR
• With the Handset OFF, dial the
phone number. Then, press the
desired LINE key. After a 2 second
delay to access dial tone, the phone
number you entered will automatically
be dialed.
NOTE: If you make a mistake while
entering digits (with the Handset OFF),
press and hold the INT.COM/DELETE
key. The LCD will begin to delete digits,
one by one, until you release the key.
If you want to delete ALL digits at once,
press and hold the CONF/CLEAR key.
All previously entered digits will be deleted,
and the LCD will be blank.
To end your call, press OFF, or return
the Handset to the Base Unit cradle.
To put a call on HOLD from the
Handset:
Press the HOLD/PAUSE key to place
a call on HOLD.
Press the appropriate LINE key to cancel
HOLD and return to the conversation.
If you are on LINE 1 and press LINE 2,
LINE 1 will automatically go into HOLD
mode. Press OFF to end your call with
LINE 2, then press LINE 1 to return to your
party on LINE 1. Otherwise, with LINE 1
on HOLD and LINE 2 active, press CONF/
CLEAR to enter CONFERENCE mode.
If you are on LINE 2 and press LINE 1,
LINE 2 will automatically go into HOLD
mode. Press OFF to end your call with
LINE 1, then press LINE 2 to return to
your party on LINE 2. Otherwise, with
LINE 2 on HOLD and LINE 1 active,
press CONF/CLEAR to enter
CONFERENCE mode.
To end a 2-Line CONFERENCE, press
OFF.
NOTE: You cannot end a call when it is
on HOLD. First, press the appropriate
LINE key, then press OFF (or return the
Handset to the Base Unit cradle).
REDIAL
Press the appropriate LINE key and listen
for dial tone. Then press REDIAL. The
most recent phone number you called will
automatically be redialed.
Similar to Making Calls above, you can
also press REDIAL with the Handset OFF,
and then press the desired LINE key. The
VT 2960
will wait 2 seconds for a dial tone,
and then REDIAL the last number you
called.
BASIC OPERATIONS