Filter
Top Products
14
Bluetooth
Bluetooth setup
To use a Bluetooth enabled cell phone or headset with your LS6245, you
must rst pair and connect your Bluetooth device(s) with the telephone base.
Setup cell
Before you begin, make sure that your Bluetooth enabled
cell phone is not connected to any other Bluetooth
device. Refer to your cell phone user's manual to learn
how to search for or add new Bluetooth devices.
To pair and connect a cell phone:
Press the MENU softkey on the telephone base
when it is not in use.
Press /VOL
+
or VOL
-
/ to highlight Bluetooth, then
press the SELECT softkey.
Press /VOL
+
or VOL
-
/ to highlight Setup cell, then
press the SELECT softkey.
If a device is already connected to the telephone
base, Connected devs will be temp.
disconnected displays. Press the OK softkey to
temporarily disconnect the device and continue
the pairing process.
Press the NEXT softkey to set the telephone base to
discoverable mode.
Turn on the Bluetooth feature of your cell phone and
search for or add new devices.
Once your cell phone nds VTech LS6245, select it.
Enter the PIN of the telephone base (the default
PIN is 0000) into your cell phone to continue the
pairing process.
When a device is successfully connected,
Device connected to base, and 1 and/or 2
displays.
When you already have two devices on the
active devices list, press the YES softkey to
connect to your paired cell phone. You are
prompted to replace an existing device on the
active devices list (page 18).
1.
2.
3.
•
4.
5.
6.
7.
8.
•
Setup cell
Setup headset
Active devices
SELECT
Page all HS
Intercom
Bluetooth
SELECT
Pls set your
cell to search
for devices
NEXT
LS6245
discoverable
PIN:0000
Pairing
complete
Device
connected
to base
The pairing process may take up to one minute. If the pairing process fails,
try again.