Filter
Top Products
3-17
Operation with a Fist Microphone
Sending an Individual Ship's Call
The RAY215 can only send a Routine Individual Call. The MMSI number
of the ship to which the Individual Call is to be sent can be input manually
or selected from a phonebook listing in memory. This section includes
instructions for using both methods and for adding numbers to the
phonebook.
Using a manually input MMSI number
1. Press and release the DSC/PRI and D/L / I.C. keys simultaneously to
place the unit in DSC mode. "70" appears in the large channel display,
the DSC indicator illuminates, and "in" appears in the small channel
display to designate individual call.
2. Press and release the DSC/PRI key. The DSC indicator appears, "0" is
displayed in the large character display, and "1" is displayed in the
small character display.
3. Rotate the Channel Select (CH) knob until the first digit of your MMSI
number appears in the large character display. (Channel UP/DOWN
keys on the microphone are disabled during this process).
4. Press the DSC/PRI key once to accept. The small character display
now shows a "2", designating the second digit in the other ship’s MMSI
number.
5. Rotate the Channel Select (CH) knob until the second digit of the
other ship’s MMSI number appears in the large channel display.
6. Press the DSC/PRI key once to accept.
7. Enter all 9 digits of the MMSI number in the same way.
8. Once the 9th digit has been entered and accepted, the RAY215 plays
back the 9 digits just entered for proper entry verification.
If the number is incorrect, press the DSC/PRI key once and release.
The radio will revert to the beginning of the entry process to start over
again. This step can be repeated as many times as required until the
number is entered correctly.
9. When the MMSI number is verified as correct, press and hold the
DSC/PRI key for 2 seconds to verify.
Note: The operation is cancelled if the 16/9 key is pressed or if no keys
are pressed for 60 seconds during any part of this process.