Filter
Top Products
2-2 Installation
2.3 Planning the Installation
When planning the installation of your RAY215, the following conditions
should be considered to ensure dependable and trouble-free operation.
Mount the Base Station Transceiver using the Mounting Template
provided.
The Base Station Transceiver is designed to be mounted horizontally or
vertically on a flat bulkhead. Select a location that is non-metallic, dry,
protected, well-ventilated, and free from high operating temperatures and
excessive vibration. Provide sufficient space behind the transceiver to
allow for proper cable connections to the rear panel connectors. Locate
the transceiver as near as possible to the power source yet as far apart as
possible from any devices that may cause interference such as motors,
generators, and other on board electronics. The transceiver should be
protected from prolonged direct exposure to rain and salt spray.
The transceiver is NOT designed to be mounted in engine compartments.
Do NOT install the transceiver in a location where there may be flammable
vapors (such as in an engine room or compartment, or in a fuel tank bay),
water splash or spray from bilges or hatches, where it is at risk from physical
damage from heavy items (such as hatch covers, tool boxes, etc.), or where
it might be covered by other equipment. Locate the Base Station
Transceiver and Handset at least 3 feet from the antenna.
Safe Compass Distance is 1 meter for a common mechanical compass;
other compass types may require greater distances. To be sure, you should
locate the radio as far as possible from the compass. Test your compass to
verify proper operation while the radio is also operating.
Mount the base station transceiver to allow easy access from the location
where the ship is normally navigated.
2.3.1 Typical Mounting Methods
The RAY215 can be conveniently mounted on a chart table, bulkhead,
overhead, or any other desired location. Refer to Figure 2-1 for typical
mounting methods.
CAUTION
Make sure there are no hidden electrical wires or other items behind
the desired location before proceeding. Check that free access for
mounting and cabling is available.