Filter
Top Products
3-11
Operation with a Fist Microphone
This will NOT erase the Own Ship's MMSI ID number for your vessel
nor will it erase the PHNBOOK entries made with the Full Function
Handset.
To perform the memory reset:
1. Turn the radio OFF.
2. Press and hold the SCAN/MEM key.
3. While continuing to hold the SCAN/MEM key, turn the radio ON.
The LCD remains blank for 2 seconds, CL appears momentarily, then
the unit switches to channel 16.
3.3.13 Scan Modes
The RAY215 is equipped with two types of scan options: All Scan and
Memory Scan. How these options are initiated is dependent upon whether
there are any channels stored in memory. Channel 70 is also monitored
during Scan mode.
All Scan Mode
If no channels are stored in memory when the SCAN/MEM key is pressed,
the radio begins scanning all channels (except weather channels) as long
as no signal is received. If a signal is received, the scan stops on the
receiving channel as long as it is present. If the signal is lost for five
seconds, the radio resumes scanning. SCAN is displayed on the LCD
while the Scan mode is active.
If the SCAN/MEM key is pressed again while SCAN is flashing, the All
Scan Standby state is suspended and the unit returns to the normal state.
To cancel the scan mode, press the SCAN/MEM key once.
Memory Scan Mode
If one or more channels are stored in memory when the SCAN/MEM key
is pressed, SCAN and MEM begin to flash simultaneously on the LCD. If
no other key is pressed within three seconds, SCAN and MEM stop
flashing and the radio begins scanning all channels currently stored in
memory. As with All Scan, if a signal is received, the scan stops on the
receiving channel until the signal is lost for five seconds, then the radio
resumes scanning. To cancel memory scan, press and release SCAN/MEM.
If there are channels stored in memory but All Scan operation is desired,
press SCAN/MEM again within the 3 second period while the SCAN and
MEM indicators are flashing.