Filter
Top Products
4.1 Troubleshooting
Installation Manual 161
4.1.4 Using the Reset Button
If the Hybrid IP-PBX does not operate properly, use the Reset Button. Before using the Reset
Button, try the system feature again to confirm whether there definitely is a problem or not.
Notes
1. When the System Clear Switch is set to the normal position, pressing the Reset
Button causes the following:
• Camp-on is cleared.
• Calls on hold are terminated.
• Calls on exclusive hold are terminated.
• Calls in progress are terminated.
• Call park is cleared.
Other data stored in memory, except the above, are not cleared.
2. After sliding the System Clear Switch towards the Reset Button, you must press the
Reset Button with caution, because all data stored in memory will be cleared by the
following operation: (1) pressing the Reset Button and then, (2) setting the System
Clear Switch back to the normal position while the RUN indicator is flashing (within
approximately 10 s).
Operation
1. If the Hybrid IP-PBX does not operate properly:
a. Make sure that the System Clear Switch is set to the normal position.
b. Press the Reset Button.
2. If the Hybrid IP-PBX still does not operate properly:
a. Slide the System Clear Switch towards the Reset Button.
b. Press the Reset Button.
c. Set the System Clear Switch back to the normal position while the RUN indicator is
flashing (within approximately 10 s).
Reset Button
System Clear Switch
RUN Indicator