Panasonic KX-TD612NZ Telephone User Manual


 
Operation
54 User Manual
Calling an external party
*1: If you dial a wrong DISA user code, dial and try again from this point.
If you enter a wrong DISA user code 3 times, the line will be disconnected automatically.
In case a destination of Intercept Routing is not assigned, the call which was made by DISA
function will be disconnected automatically when it is over a programmed time period.
If Built-in Automated Attendant service is set, you can access the desired extension
simply by pressing 1 digit number (0-9) according to the outgoing message.
You can select either to direct a call to the pre-programmed Intercept Routing destination
or to disconnect it without respect to the pre-programmed Intercept Routing destination
(default: direct the call to the pre-programmed Intercept Routing destination) when a caller
dials nothing for the pre-determined period of time (default: 5 s later) after hearing DISA
OGM. System Programming is required. Consult your dealer.
In Non Security Mode
Any Outside Telephone
Enter line
access number
(9 or 81-84).
line access
no.
Enter DISA
phone number.
DISA
phone no.
phone no.
Enter phone
number of the
external party.
DISA OGM
D.Tone
Enter line
access
number
(9 or 81-84).
line access
no.
DISA user
code
Enter DISA
phone number.
DISA
phone no.
phone no.
In Trunk Security Mode
Enter phone
number of the
external party.
Enter pre-assigned
DISA user code
(4-10 digits).
D.Tone
Enter DISA
phone number.
DISA
phone no.
phone no.
In All Security Mode
Enter phone
number of the
external party.
D.Tone
DISA user
code
Enter pre-assigned
DISA user code
(4-10 digits).
Enter line
access
number
(9 or 81-84).
line access
no.
1
1
D.Tone
D.Tone
DISA OGM
DISA OGM