Filter
Top Products
AD-25182501CHAPTER 3
Page 110
Revision 1.0.1
NAP- 200-009
Sheet 3/3
System Initialization and System
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
Data Entry
To reset CAT mode:
While “COMMAND = -” is displayed on LCD:
1. Lift the handset (off hook)
- SPKR lamp is off.
2. Replace the handset (on hook)
- CNF, ANS lamps are off.
- LCD returns to clock.
2.2 MAT (Maintainance Administration Terminal)
In addition to the CAT mode programming, the MAT can also be used. Refer to the MAT Operation Guide and the
Command Manual.
Note
: An AUSTEL-Approved Isolator must be connected between the MAT and the PABX’s I/O port;
Refer to the trunking diagram on page 3.