Filter
Top Products
6-16 Chapter 6: Hardware Service
21. Remove the Keylock by prying the Retaining Clip off with a small
screwdriver.
22. The LED Board can be removed by prying off the Tinnerman Clip.
19925
Keylock Retaining Clip
Tinnerman Clip
Replacing the Keylock assembly
1. Align the tabs and snap into place.
2. Carefully route the wires through the bezel.
Re-Assembling the DynaKey
To re-assemble the DynaKey module, use the reverse order of the
previous procedures. In addition, check the following:
1. Before closing the cabinet, check the LCD to make sure there are no
fingerprints or lint particles on it.
2. Make sure the cables are routed properly before closing the cabinet.