Filter
Top Products
Chapter 3: Hardware Installation 3-15
9. Route the cable(s) through the upper half of the Checkstand Base
and install the Thumbscrew and the Front Cover. Be sure to leave
enough slack in the cable(s) to permit easy tilting of the
DynaKey.
10. Route the cable(s) into the lower half of the Checkstand Base and
through the countertop.
11. Slide the Side Cover onto the lower half of the Checkstand Base.
12. Slide the upper half of the Checkstand Base into the lower half of
the Checkstand Base and tighten the Thumbscrew.
Powering Up
This section describes how to power up the system and the initial
checkout procedures after all hardware has been installed.
1. Plug the terminal AC Power Cord into an AC power source.
2. Turn the Keylock on the DynaKey to the Ex position.
3. Power on the system.
Special Keypad Mode
The BIOS setup routine requires keys that are not present in the regular
DynaKey keypad layout (such as the ESC and End keys). Although the
DynaKey has a PC keyboard port, a PC keyboard may not be readily
available to the operator. To use the DynaKey to run setup routines,
you can place the DynaKey into a special alternate layout mode that
replaces the normal layout of the keypad and function keys. To enter
the special Setup Keypad Mode, proceed as follows: