Multi-Tech Systems MVP-2410 IP Phone User Manual


 
MultiVOIP User Guide Mechanical Installation
99
Proceed to Chapter 4 “Software Installation.”
Cabling Procedure for MVP-410/410G/810/810G
Cabling involves connecting the MultiVOIP to your LAN and telephone
equipment.
1.Connect the power cord supplied with your MultiVOIP to a live AC outlet
and to the power connector on the back of the MultiVOIP as shown at top
right in Figure 3-11.
Ethernet Connection
Command Port Connection
COMMAND
ETHERNET
10 BASET
E&M FXS/FXO
E&M FXS/FXO
E&M FXS/FXO E&M FXS/FXO
E&M
FXO
PSTN
E&M FXS/FXO
FXS
E&M FXS/FXO
E&M FXS/FXO
E&M FXS/FXO E&M FXS/FXO
Voice/Fax Channel Connections
Channels 1-4 Bottom MVP410/810
Channels 5-8 Top MVP810 Only
Figure 3-11: Cabling for MVP-410/410G/810/810G
2.Connect the MultiVOIP to a PC by using a DB-25 (male) to DB-9 (female)
cable. Plug the DB-25 end of the cable into the Command port of the
MultiVOIP and the other end into the PC serial port. See Figure 3-11.
3.Connect a network cable to the ETHERNET 10BASET connector on the
back of the MultiVOIP. Connect the other end of the cable to your network.
4.If you are connecting a station device such as an analog telephone, a fax
machine, or a Key Telephone System (KTS) (FXS interface), or a PBX
extension (FXO interface) to your MultiVOIP, connect one end of an RJ-11
phone cord to the Channel 1 FXS/FXO connector on the back of the
MultiVOIP and the other end to the device or phone jack. You will define
the interface in the Interface dialog box in the software when you configure
the unit.