Filter
Top Products
MultiVOIP User Guide Quick Start Instructions
81
Connectivity Test
The procedures “Phone/IP Starter Configuration” and “Phonebook Starter
Configuration” must be completed before you can do this procedure.
1. These connections must be made:
Connections
for digital MultiVOIPs
(MVP-2400/2410/3010
for analog MultiVOIPs
(MVP-130/210/410/810,
MVP-210G/410G/810G)
MultiVOIP to local PBX MultiVOIP to local phone
station
–OR--
MultiVOIP to extension of key
phone system
MultiVOIP to command PC MultiVOIP to command PC
MultiVOIP to Internet MultiVOIP to Internet
2. Inbound Phonebook and Outbound Phonebook must both be set up with at
least one entry in each. These entries must allow for connection between
two voip units.
3. Console messages must be enabled. (If this has not been done already, go,
in the MultiVOIP GUI, to Configuration | Logs and select the “Console
Messages” checkbox.
4. You now need to free up the COM port connection (currently being used by
the MultiVOIP program) so that the HyperTerminal program can use it. To
do this, you can either (a) click on Connection in the sidebar and select
“Disconnect” from the drop-down box, or (b) close down the MultiVOIP
program altogether.