Multi-Tech Systems MVP-2410 IP Phone User Manual


 
Technical Configuration (Analog/BRI) MultiVOIP User Guide
198
Functional Equivalence of Interfaces. The MultiVOIP configuration
program is required to do the initial configuration (that is, setting an IP address
for the MultiVOIP unit) so that the VOIP unit can communicate with the
MultiVoipManager program or with the web browser GUI. Management of
the VOIP after that point can be done from any of these three programs since
they all offer essentially the same functionality. Functionally, either the
MultiVoipManager program or the web browser GUI can replace the
MultiVOIP configuration program after the initial configuration is complete
(with minor exceptions, as noted).
WARNING: Do not attempt to interface the MultiVOIP unit with two
control programs simultaneously (that is, by accessing the
MultiVOIP configuration program via the Command Port
and either the MultiVoipManager program or the web
browser interface via the Ethernet Port). The results of
using two programs to control a single VOIP
simultaneously would be unpredictable.