Multi-Tech Systems MVP-2410 IP Phone User Manual


 
Technical Configuration (Analog/BRI) MultiVOIP User Guide
246
The Regional Parameters fields are described in the table below.
“Regional Parameter” Definitions
Field Name Values Description
Country/
Region
USA, Japan, UK,
Custom
Note:
“Survivability”
tone indicates a
special type of
call-routing
redundancy &
applies to
MultiVantage voip
units only.
Name of a country or region that uses a
certain set of tone pairs for dial tone,
ring tone, busy tone, and
‘unobtainable’ tone (fast busy tone),
survivability tone (tone heard briefly, 2
seconds, after going offhook denoting
survivable mode of voip unit) and re-
order tone (a tone pattern indicating
the need for the user to hang up the
phone). In some cases, the tone-pair
scheme denoted by a country name
may also be used outside of that
country. The “Custom” option
(button) assures that any tone-pairing
scheme worldwide can be
accommodated.
Type column
dial tone,
ring tone,
busy tone,
unobtainable tone
(fast busy),
survivability tone,
re-order tone
Type of telephony tone-pair for which
frequency, gain, and cadence are being
presented.
Frequency 1 freq. in Hertz Lower frequency of pair.
Frequency 2 freq. in Hertz
Higher frequency of pair.
Gain 1
gain in dB
+3dB to –31dB
and “mute” setting
Amplification factor of lower
frequency of pair.
This applies to the dial, ring, busy and
‘unobtainable’ tones that the
MultiVOIP outputs as audio to the
FXS, FXS, or E&M port. Default: -
16dB
Gain 2
gain in dB
+3dB to –31dB
and “mute” setting
Amplification factor of higher
frequency of pair.
This applies to the dial, ring, busy, and
‘unobtainable’ (fast busy) tones that
the MultiVOIP outputs as audio to the
FXS, FXO, or E&M port. Default: -
16dB