Multi-Tech Systems MVP-2410 IP Phone User Manual


 
MultiVOIP User Guide Technical Configuration (Digital Voips)
123
Write down the values for these IP parameters. You will need to enter these
values in the “IP Parameters” screen in the Configuration section of the
MultiVOIP software. You must have this IP information about every VOIP in
the system.
T1 Telephony Parameters (for MVP2400 & MVP2410)
The following parameters must be known about the PBX or telco central office
equipment to which the T1 MultiVOIP will connect:
T1 Phone Parameters
Ask phone company or
PBX maintainer.
Info needed to operate:
MVP2400
MVP2410
T1 Telephony Parameters:
Record for this VOIP Site
#
Which frame format is used? ESF___ or D4___
Which CAS or PRI protocol is used? ______________
Clocking: Does the PBX or telco switch use
internal or external clocking? _________________
Note that the setting used in the voip unit will be the
opposite of the setting used by the telco/PBX.
Which line coding is used? AMI___ or B8ZS___
Write down the values for these T1 parameters. You will need to enter these
values in the “T1/E1 Parameters” screen in the Configuration section of the
MultiVOIP software.